Apply The Decals - Seagull Models Radial Rocket JD 10cc Assembly Manual

RADIAL ROCKET 10cc
INSTALLATION PILOT AND CANOPY.
1) Locate items necessary to install pilot,
.
seats.
2) A scale pilot is included with this ARF.
The Seagull Pilot included fitting well to
the cockpit. (or you can order others scale
pilot figures made by Seagull factory.
They are available at Seagull distributors.)
If you are going to install a pilot figure,
please use a sanding bar to sand the base
of the figure so that it is flat.
3) Position the pilot figure on the canopy
floor as show. Locate the oval shaped on
the canopy floor and remove the cover-
ing. Use epoxy to glue this into the base
of the pilot figure and glue the cockpit
panel in place with C/A glue, please see
pictures as shown.
28
Instruction Manual.
170mm
4) Position the canopy onto the fuselage.
Trace around the canopy and onto the
fuselage using a felt-tipped pen.
C/A glue.

APPLY THE DECALS.

1) If all the decals are precut and ready to
stick. Please be certain the model is clean
and free from oily fingerprints and dust.
Position decal on the model where de-
sired, using the photos on the box and aid
in their location.
2) If all the decals are not precut, please
use scissors or a sharp hobby knife to cut
the decals from the sheet. Please be cer-
tain the model is clean and free from oily
fingerprints and dust. Position decal on
the model where desired, using the pho-
tos on the box and aid in their location.
Epoxy.