Seagull Models Radial Rocket JD 10cc Assembly Manual page 12

RADIAL ROCKET 10cc
Cut
8) Reinstall the servo horn by sliding the
connector over the pushrod wire. Center
the throttle stick and trim and install the
servo horn perpendicular to the servo
center line.
9) Move the throttle stick to the closed po-
sition and move the carburetor to closed.
Use a 2.5mm hex wrench to tighten the
screw that secures the throttle pushrod
wire. Make sure to use threadlock on the
screw so it does not vibrate loose.
12
Instruction Manual.
COWLING.
Please see these below pictures.