Clarke CBS45MD Operation & Maintenance Instructions Manual page 9

ASSEMBLY
The bandsaw comes partly assembled. Unpack and lay out all the items and
identify each one, referring to the overview on page 8.
If any parts are missing, immediately contact the dealer where the product
was purchased.
CAUTION: IF THERE IS ANY UNCERTAINTY REGARDING ELECTRICAL
CONNECTIONS, YOU SHOULD CONSULT A QUALIFIED ELECTRICIAN.
LEGS AND TOOL TRAY ASSEMBLY
• The legs are a three sided section, one side of which is hinged.
1. Attach the tool tray between the
legs, as shown, (i.e. tray edges
uppermost), using the four nuts,
bolts and washers supplied. Leave
the nuts finger tight at this stage.
NOTE: The special "D" shaped
washer should be inside the
leg with the nut.
2. Gently lower the bandsaw onto
the legs.
CAUTION: TWO PEOPLE WILL BE REQUIRED FOR THIS TASK
3. Secure the bandsaw to the legs
using three nuts, bolts and
washers at the top of each leg.
Make sure there is no distortion.
NOTE: The machine bed may fit
either way round.
4. Tighten all the tray nuts and bolts,
checking for distortion and
stability.
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
9