Specifications - Clarke CBS45MD Operation & Maintenance Instructions Manual

7. Never use bent or cracked blades. (Replacement blades are available
from your Clarke dealer.
8. When cutting wood, ensure all nails or fastenings have been removed
beforehand.
9. When cutting round stock, use a suitable jig or fixture to keep the work from
turning.
10. Always ensure the blade is fully tightened and correctly adjusted before
use.
11. Keep the mains power cable well away from the machine and ensure an
adequate electrical supply is close at hand so that the operation is not
restricted by the length of the cable.
12. Switch the machine off immediately the task is completed.

SPECIFICATIONS

Weight
Dimensions (W x H x D)
Table Height from Floor
Tilt angle
Maximum Cutting capacity@90
Blade Speed (3 speeds)
Blade Size
Supply Cable Length
Sound Power Level Measured (Lw) less than 78 dB(A) whilst cutting
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
64 kg
1100 x 960 x 1500 mm
610 mm
o
0 - 45
o Round section 100 mm
Flat 100 x 150 mm
20, 29, 50 m/min
1638 x 12.7 x 0.65 mm - 14 tpi
2000 mm
6