Ethernet Configuration; User-Defined Modbus Addressing; Default Address - Moxa Technologies ioLogik E1200 Series User Manual

ioLogik E1200 Series

Ethernet Configuration

On the Ethernet Configuration page, you can set up a static or dynamic IP address for the ioLogik E1200, and
configure the subnet mask and gateway address.

User-defined Modbus Addressing

User-defined Modbus Addressing
The input and output address can be configured in a different format on a specific settings page. Check the
"Enable User-defined Modbus Addressing" box, select the Modbus function, and then configure the start
address of each item.
ATTENTION
Disable the user-defined modbus addressing function if using the MXIO(.NET) library or using Active OPC
Server to control or monitor the ioLogik E1200's I/O Status.

Default Address

On this settings page, you can view the default Modbus address for all I/O devices. The page only displays the
start address of each item. For example, if the DI Value starts from 10001, then the 1
address is 10001 and the 2
nd
DI is 10002.
3-4
Using the Web Console
st
DI channel's Modbus