Tektronix 1S1 Instruction Manual page 66

Series resistance approximately 200 ohms. Tektronix part
number 010-0120-00.
14. Cathode-follower probe, Tektronix P6032. Minimum
alternate requirements: Compatible with Type 1S1 PROBE
POWER connector. Required only for loading PROBE
POWER connector during voltage checks. A 70-ohm 5-watt
resistor may be substituted for the probe.
15. 30-inch flexible 1-series plug-in extension cable. Tek-
tronix part number 012-0038-00.
16. 10-nsec coaxial cable (RG-58A/U) with GR 50-ohm
connectors. Tektronix part number 017-0501-00.
17. 42-inch coaxial cable with BNC connectors. Char-
acteristic impedance approximately 50 ohms. Tektronix
part number 012-0057-00.
18. Two 18-inch patch cords with banana connectors on
both ends. Tektronix part number 012-0024-00.
19. Two 18-inch patch cords with BNC connector on one
end and banana connector on other end.
20. Four 10X T-attenuators with GR 50-ohm connectors.
Tektronix part number 017-00"-00.
21. Two 5X T-attenuators with GR 50-ohm connectors.
Tektronix part number 017-0045-00.
Fig. 5-2. Small calibration equipment and tools.
22. 2X T-attenuator with GR 50-ohm connectors. Tektronix
part number 017-0046-00.
23. 2X T-attenuator with BNC connectors. Tektronix part
number 011-0069-00.
24. Variable attenuator with GR 50-ohm connectors. Tek-
tronix part number 067-0511-00. Fixed attenuators, as re-
quired, may be substituted.
25. Coaxial T-connector with GR 50-ohm connectors. Tek-
tronix part number 017-0069-00.
26. Plastic screwdriver-type adjustment tool. Shaft length 1½
inches. Tektronix part number 003-0000-00.
27. Plastic tool with recessed screwdriver tips. Length
7 inches. Tektronix part number 003-0003-00 or Walsco
2519.
28. GR-to-BNC plug connector adapter. Tektronix part
number 017-0064-00.
29. GR-to-BNC jack connector adapter. Tektronix part
number 017-0063-00.
30. Clip-lead adapter with BNC jack connector. Required
only for checking input dc resistance. Tektronix part num-
ber 013-0076-00.
31. Other connector adapters as required for adapting
between connector types.
Calibration – Type 1S1
5-3