Tektronix 1S1 Instruction Manual page 148

VOLTAGE AND WAVEFORM
Typical voltage measurements and waveform photographs (shown in
blue) were obtained under the following conditions unless noted other-
wise on the individual diagrams:
Test Oscilloscope:
Bandpass
Probe input Impedance
Probe Ground
Triggering
Dc Voltmeter:
Type
Sensitivity
Type 1S1 Conditions-
Installation
Vertical Input Signal
External Triggering Signal
Type 1S1 Control Settings:
mVOLTS/CM
mVoIts/Crn VARIABLE
VERT POSITION
DC OFFSET
TIME/CM
Time/Cm VARIABLE
TIME POSITION RANGE
TIME POSITION
Time Position FINE
SMOOTHI`NG
SAMPLES/CM
DISPLAY MODE
MANUALSCAN
EXT HORIZ ATTEN
TRIGGER SOURCE
TRIGGER SENSITIVITY
RECOVERY TIME
(Continued on MEMORY
TEST CONDITIONS
Dc to 30 Mc
10 Megohms, 7 picofarads
Clipped to Type 1S1 chassis
External from point indicated
on diagram
Volt-Ohmmeter
20,000 ohms/volt
Connected to oscilloscope
through 30-inch flexible
extension
None
None
200
CAL (at detent)
Centered
Zero volts at OFFSET OUTPUT
50 nSEC
CAL (at detent)
500 nS (locked to TIME/CM)
Centered
Centered
NORM (clockwise)
MIN (clockwise)
NORMAL
Clockwise
INT +
Clockwise
SYNC
diagram)