Installing The Engine Mount; Installing The Stopper Assembly - Black Horse Model MUSTANG P51 Instruction Manual Book

MUSTANG P51 -

INSTALLING THE ENGINE MOUNT.

See pictures below:
ENGINE MOUNT.
14
Item code: BH33 .
Drill a hole
4mm diameter
4 X 30mm
Instruction Manual
FUEL TANK.

INSTALLING THE STOPPER ASSEMBLY

 1) The stopper has been pre-assembled
at the factory.
 2) Using a modeling knife, cut one length
of silicon fuel line (the length of silicon fuel line
is calculated by how the weighted clunk should
rest about 8mm away from the rear of the tank
and move freely inside the tank). Connect one
end of the line to the weighted clunk and the
other end to the nylon pick up tube in the stop-
per.
 3) Carefully bend the second nylon tube
up at a 45 degree angle (using a cigarette
lighter). This tube will be the vent tube to the
muffler.
 4) Carefully bend the third nylon tube down
at a 45 degree angle (using a cigarette lighter).
This tube will be vent tube to the fueling valve.
When the stopper assembly is installed in the
tank, the top of the vent tube should rest just
below the top surface of the tank. It should not
touch the top of the tank.