Advertisement
Assembly of the Storage
to Beam Tether Brackets
1.
Select the inboard set of holes
from the left side and right side to
install the storage to beam tether
brackets.
TIP: Use the alternative sets of holes
to prevent interference of the storage
to beam tether bracket to a power and
data cover or to a desk tether.
Fasten the storage to beam tethers to
the case.
TIP: Lock nuts may be included in the
tether bracket kit but are not required in
this c:scape low storage application.
2.
With the case close to the beam,
adjust the height of the case as
indicated below:
1-1/2 High Unit: The top surface of
the case is flush to the beam.
1 High Unit: The underside of the top
is flush to the underside of the beam.
Adjusting Glides from
STORAGE TO BEAM
TETHER BUTTON
TETHER BRACKET
NOTICE: Do not push
until tether bracket
has been assembled
to the storage unit.
1
Glide Adjustment
#10-32 x 1/2" PAN HEAD SHOULDER SCREW
PHILLIPS SQUARE DRIVE
QTY 4 PER CASE
NOTICE: Do not exceed
40 in-lbs of torque.
FLUSH
2
1 High Unit
SIDE VIEW
FLUSH
1-1/2 High Unit
Page 13 of 15
939500368 Rev K
Advertisement
