Boot Sequence Submenu - Xycom XVME-655 Manual

Boot Sequence Submenu

This menu lets you configure the boot sequence.
PhoenixBIOS Setup–Copyright 1985-95 Phoenix Technologies Ltd.
Main
Boot Sequence
Previous Boot:
Boot sequence:
SETUP Prompt:
POST Errors:
Floppy check:
Summary screen:
­¯
F1 Help Select Item
¨ Select Menu
ESC Exit
Option Description
Previous Boot Detects if a boot sequence was not completed properly, if enabled. A power
failure, reset during boot-up, or invalid CMOS configuration may cause an
incomplete boot. If BIOS detects this, it displays the message "Previous boot
incomplete - default configuration used." The system will be rebooted using the
default configuration. If this option is disabled, the system BIOS does not detect an
incomplete boot, and the system may not boot if CMOS settings are wrong. The
default is disabled.
Boot Sequence Attempts to load the operating system from the disk drives in the sequence
selected here. The default is A: then C:
Setup Prompt Displays the message, "Press <F2> to enter Setup," during boot up. The default is
disabled.
POST Errors Halts the system if it encounters a boot error when enabled, and will display "Press
<F1> to resume, <F2> for Setup." The default is enabled.
Floppy Check Seeks disk drives on the system during boot up if enabled. Disabling speeds boot
time. The default is enabled.
Summary Screen Displays the system summary screen during boot up when enabled. The default is
enabled. This screen is a standard Phoenix BIOS screen and provides information
on the following items:
Processor Type
Coprocessor Type
BIOS Date
System ROM Address
System RAM
Extended RAM
Shadow RAM
Cache RAM
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
[Disabled]
[A: then C:]
[Disabled]
[Enabled]
[Enabled]
[Enabled]
-/+ Change Values
Select } Sub-Menu
Enter
Figure Chapter 3 -5. Boot Sequence Submenu
COM Ports
LPT Ports
Display Type
Hard Disk 0
Hard Disk 1
Diskette A
Diskette B
Chapter 3 – BIOS Setup Menus
Item Specific Help
If the line item you are
viewing has specific help,
it will be listed here.
F9 Setup Defaults
F10 Previous Values
3-7