ADLINK Technology cPCI-6525 User Manual page 44

COM1 Mode Switch (SW12)
Switch SW12 sets the mode of the COM1 port on the front panel.
IPMC Mode Switch (SW_MOD1)
Switch SW_MOD1 is a multi purpose switch that allows users to
define the blade operating mode. All are set to OFF by default.
Pin# Status
1 OFF Reserved
When the system does not include a Chassis Management
OFF Module (CMM), set this pin to OFF to allow IPMI to run in
"without CMM mode" (default).
2
When the system includes a CMM, set this pin to ON to allow
ON
IPMI to run in "with CMM mode".
3 OFF Reserved
The power on/off is state is controlled by the ejector handle
OFF
state. Do not change the default setting (OFF).
4
ON Force the ejector handle state to "closed".
34
ON
1
Mode
RS-232 (default)
RS-422
RS-485
ON
1 2
2
1
ON OFF
ON ON
OFF ON
3 4
Description
2
Board Interfaces