Selecting Run Time; Run Time Selection; Continuous Operation - Fisher Scientific accuSpin 1 Operating Instructions Manual

Operation

Selecting run time

You can select a run time between 1 min and 9 h 59
min and 10 h up to 99 h (from 10 h in one-hour steps),
or continuous operation (hLd).

Run time selection

To set a time, proceed as follows:
1. Press one of the "set" keys
(for a decrease) in the "run time" section of the
control panel once to switch from the actual to the
set point mode.
2. By briefly pressing the "set" key you
42
(for an increase) or
can now
raise or lower the run
time in 1-minute incre-
ments.
3 If you keep the selected key pressed, the dis-
play changes at first slowly and after a few
seconds at an accelerated pace.
4 Release the key as soon as you have reached
the desired value, and adjust if necessary by
repeatedly pressing the key.
The minute display flashes for a number of
seconds, then changes to permanent display.
The run time is now stored.
You may shift the flashing cursor to set the value as
described under "Selecting speed".

Continuous operation

To switch the accuSpin™ to the continuous mode, you
must press the key until the display reads "hLd") .
With this setting, the centri-
fuge keeps run until stopped
manually.