Check Remaining Run
Time
Temperature Probe
Control Mode
Check the remaining run time during a timed operation by performing
the following.
(1) Press TIMER Button once to check the remaining time during timed
operation.
After 15 seconds, the mode will be escaped automatically.
Escape of timer mode is shown as below.
Step 1: Press RUN/STOP Button.
Step 2: Turn the Stirrer Knob clockwise and press the Stirrer Knob.
Connect temperature probe to the unit. The default mode will be
automatically changed to the Temperature Probe Control Mode and
display shows the temperature value detected by the probe.
[For the temperature probe connection to the unit, Refer to Connecting
Temperature Probe]
4-12
Section 4
Control Panel