Shut Down Procedure; Linestar Shut Down During Irrigation; Automatic Shut-Off Of Linestar - Bauer LINESTAR 9000 Operating Manual

ATTENTION: The "pivoting" operating mode is not intended for the LINESTAR with below ground guidance.
 Connect supply hose to hydrant and central unit.
 Flip up skids of furrow guidance and fasten them on the central unit
 Put switch "GENSET OFF - ON" to "OFF".
 Start the generator unit.
 Put main switch to „I".
 Put switch "LINESTAR OFF – ON" to "ON".
 Swivel central unit wheels according to point 17.5
 Lower pivoting device (hydraulic stand) by means of hydraulic hand pump
 Establish water supply
 Control panel
 Press key „Enter (Menu)", the cursor starts blinking.
 Select mode "Pivoting" with + - keys.
 Confirm with „Enter".
 Exit programming mode with „ESC".
 Press "Forward" or „Reverse" key depending on travel direction
 Change application rate with + - keys.
 Put switch "GENSET OFF – ON" to „ON".

17.7 SHUT DOWN PROCEDURE

17.7.1 LINESTAR SHUT DOWN DURING IRRIGATION

Control panel LINESTAR PRO / PRO-G
 Press "ESC - Stop" key
If switch "GENSET OFF - ON" has been put to "ON", the generator unit shuts down automatically. If the switch has
been turned to „OFF" the generator unit must be shut down separately. The water supply is cut automatically by the
shut-off valve.

17.7.2 AUTOMATIC SHUT-OFF OF LINESTAR

A switch mounted on the tower shuts down the LINESTAR automatically, when it is actuated by a shut-off bar
which has been placed at the end of the field (optional equipment).
50
Schwenkeinrichtung
Swivelling device
Operating Manual for BAUER LINESTAR 9000 with hose feed