Checking Alignment - Bauer LINESTAR 9000 Operating Manual

With hose feed

Table of Contents

ATTENTION!

First of all the system must be perfectly aligned before the adjustment of the alignment control is to be started.

Then adjust the switch cam by winding the screws on the threaded rod until the roller of the control switch is

touching notch „A" just in the middle between the switching point and the reversing point (in between both clicks).

This guarantees the same control angles in FORWARD and REVERSE run.

Adjust the micro switches as follows:

3. Wind back the control cam by half of the counted nut or wrench turns to make the switch roller rest exactly in the

middle between switching and reversing point of the control switch.

15.8 CHECKING ALIGNMENT

The LINESTAR is best aligned, if the system is forming a slight regular forward bow in both travel directions.

If this is not the case, realign the system as follows:

 Turn main switch to position "1"

 Start generator unit

 Turn safety circuit switch to "ON"

 Turn „LINESTAR" switch to "ON"

 Control panel LINESTAR PRO / PRO-G

 Press "ENTER" key (Menu), the cursor starts blinking

 Press "+" and "-" keys to set „LINEAR" mode

 Confirm with "ENTER" key

 Press "ESC" to exit programming mode

Operating Manual for BAUER LINESTAR 9000 with hose feed

Make sure that the main switch is in position „0" Lock the switch against unintentional

re-closing or lock the door of the control box.

Twist the control cam by turning the hexagonal nut on the threaded rod until the

control switch touches notch „A" and responds.

2. Rotate the control cam clockwise up to the reversing switch point (click) of the

control switch, count the number of rotations of the nut or the turns with the

wrench.

4. Fix the adjustment nut with the lock nut on the

threaded rod. Adjust the two other nuts in such a

way to preload the spring by about 10 mm.

Table of Contents