Starting The Linestar In Operating Mode "Wheel Swivelling; Starting The Linestar In Operating Mode "Pivoting - Bauer LINESTAR 9000 Operating Manual

With hose feed

Table of Contents

17.5 STARTING THE LINESTAR IN OPERATING MODE "WHEEL SWIVELLING"

Conditions:

 You have the LINESTAR with cable or furrow guidance.

 The central unit must be positioned directly above the swivelling point.

 The swivelling range must be clear of weeds or obstacles.

 The tracks which are to be crossed must not be deeper than 100 mm.

 Remove guidance cable from clips around towers (cable guidance)

 Disconnect supply hose from central unit.

 Flip up skids of furrow guidance and attach to central unit.

 Disconnect the supply hose from the central tower.

 Fold up the skids of the furrow guidance and affix them to the central tower.

 Put switch "GENSET OFF - ON" to „OFF"

 Start the generator unit

 Turn main switch to position „1"

 Put switch "LINESTAR OFF - ON" to „ON".

Control panel LINESTAR PRO / PRO-G

 Press „ENTER (MENU)" key, the cursor starts blinking

 Select mode „WHEEL SWIVELLING" with „+/-" keys

 Confirm with „ENTER"

 Press „ESC" to exit programming mode

 Detach fixing device of drive console at wheel carrier.

 Press one of the arrow keys to see which one of the motors gets started.

 Press arrow keys „FORWARD / REVERSE" to swing concerned wheel by 90°.

 Fix wheel with wheel brace.

 Press both arrow keys of control box simultaneously to skip to second motor.

 Press arrow keys of control box to swing second wheel by 90°

 Fix with wheel brace.

 Remove driving pin of gearbox (freewheel).

Operating Manual for BAUER LINESTAR 9000 with hose feed

Table of Contents