Table of Contents
Advertisement
Position the antenna support such that the below ground cable is located within the regulation range (regulation
window). The safety circuit of the system is closed again. You can now start up the LINESTAR as described above.
If you do not want to move the antenna support and would rather move the entire system toward the linear
guidance, then proceed as follows:
Go to the Machine Parameters Menu on the control panel of the LINESTAR PRO / PRO-G. Increase the value in
the safety circuit window under the menu item STEERING SAFETY CIRCUIT until this is large enough to cover the
below ground cable.
45
Operating Manual for BAUER LINESTAR 9000 with hose feed
Advertisement
Table of Contents
