Humidity Sensor - HP Performance Optimized Datacenter 20c Maintenance And Service Manual

Replacing the EPO temperature sensors
Reconnect the replacement thermister coupling (1).
1.
Secure the thermister with tie wraps (2).
2.

Humidity sensor

The HP POD 20c contains one humidity sensor. It is located in the cold aisle in cooling zone 2.
You need a screwdriver to remove and replace the humidity sensor.
Removing the humidity sensor
Remove the four screws that secure the sensor cover (1), and then remove the cover (2).
1.
Remove the two self-tapping screws (3).
2.
Identify the sensor wires.
3.
Disconnect the sensor wires.
4.
Removal and replacement procedures 62