8 - 2 ADJUSTING THE VOLUME
Never touch places other than those specified. Touching unspecified places can
cause electric shock and/or short circuit.
After the replacement or adjustment of the VR, be sure to set the variable value of
the VR in the test mode's Volume Setting.
The Volume Brackets can be
1
moved by loosening 2 screws from
each Bracket.
Move the Volume Brackets to
2
disengage the Adjust Gear mesh,
and move the Volume Shaft so that
the cut portion of the Volume Shaft
faces opposite the Center Refer-
ence Hole of the Adjust Gear.
Engage Gears and fasten the 2 screws.
3
4
Carefully move the CONTROL WHEEL left/right & forward/backward, and check to ensure that the
Volume range is not exceeded
5
Upon completion of adjustment, be sure to perform Volume Setting in the TEST mode.
8-3 REPLACING THE VOLUME
1
Disconnect the wiring connector.
2
Take out the 2 screws which secure the volume Bracket and remove the Volume Bracket.
3
Take out the 2 screws to remove the Volume Gear and replace the Volume.
4
After replacing the Volume, follow the steps in 8-2 to adjust theVolume.