A Input Test; B Output Test - Sega Airline Pilots Owner's Manual

A. INPUT TEST
Select INPUT TEST to have the screen shown below appear and to observe the status of each switch
and the value of each V.R. on the Control Panel. In this mode, Periodically check the status of each
switch and V.R.
INPUT TEST
LANDING GEAR SWITCH
FLAP SWITCH
VIEW CHANGE BUTTON
START BUTTON
SERVICE
TEST
CONTROL WHEEL (AILERON)
CONTROL WHEEL (ELEVATOR)
RUDDER PEDAL
THRUST LEVER L
THRUST LEVER R
PRESS TEST AND SERVICE BUTTON TO EXIT
B. OUTPUT TEST
Select OUTPUT TEST to cause the following screen to appear, and allows the status of each lamp to
be checked. In this mode, periodically check the lamp status.
OUTPUT TEST
START BUTTON LAMP
LANDING GEAR UP LAMP
LANDING GEAR DOWN LAMP
FLAP UP LAMP
FLAP DOWN LAMP
VIEW CHANGE BUTTON LAMP
-> EXIT
SELECT WITH SERVICE BUTTON
AND PRESS TEST BUTTON
By pressing each switch, if the display on the right-hand side
of the name of each switch changes to ON from OFF, the SW
UP
and the wiring connections are satisfactory. UP and DOWN
UP
are displayed for LANDING GEAR SWITCH and FLAP
OFF
SWITCH.
OFF
OFF
OFF
Operate CONTROL WHEEL, THRUST LEVER, etc. to
ABH
check Volume value display variation.
ABH
ABH
To check CHUTE 1 & CHUTE 2 coin switches, open the
ABH
ABH
COIN CHUTE DOOR and insert a coin(s) in the slot.
Simultaneously pressing the TEST BUTTON and the
SERVICE BUTTON returns to the test menu.
Select the item with the SERVICE button and press the TEST
button to alternate the display to and from ON and OFF.
Outputting corresponds to the ON/OFF alternation.
OFF
OFF
OFF
When exiting from OUTPUT TEST with ON display, all of
OFF
ON displays change to OFF.
OFF
OFF
Bring the arrow to EXIT and press the TEST BUTTON to
return to the menu mode.