Mode S Transponder - Garmin G1000 NXI Cockpit Reference Manual

3) Turn the small FMS Knob to begin data entry and change each digit.
4) Turn the large FMS Knob to move the cursor to the next digit position.
5) Press the ENT Key to complete data entry for the standby frequency.
Transferring the active and standby adF frequencies:
1) Turn the large FMS Knob to place the selection cursor over the standby ADF frequency
field.
2) Press the ENT Key to complete the frequency transfer.
Selecting an adF receiver mode:
1) Turn the large FMS Knob to place the selection cursor over the ADF mode field.
2) Turn the small FMS Knob to select the desired ADF receiver mode.
adjusting adF receiver volume:
1) Turn the large FMS Knob to place the selection cursor over the ADF volume field.
2) Turn the small FMS Knob to adjust volume as desired.
Selecting dME transceiver pairing:
1) Press the adF/dME or dME Softkey to display the 'ADF/DME Tuning' Window.
2) Turn the small FMS Knob to select the DME tuning mode.
3) Press the ENT Key to complete the selection.

ModE S TRaNSPoNdER

Selecting a transponder mode:
1) Press the XPdR Softkey to display the Transponder Mode Selection Softkeys.
2) Press the desired softkey to activate the transponder mode.
Entering a transponder code with softkeys:
1) Press the XPdR Softkey to display the Transponder Mode Selection Softkeys.
2) Press the Code Softkey to display the Transponder Code Selection Softkeys, for digit entry.
3) Press the digit softkeys to enter the code in the code field. When entering the code, the
next softkey in sequence must be pressed within 10 seconds, or the entry is cancelled
and restored to the previous code. Press the BKSP Softkey to move the code selection
cursor to the previous digit. Five seconds after the fourth digit has been entered, the
transponder code becomes active.
Entering a transponder code with the PFd FMS Knob:
1) Press the XPdR and the Code Softkeys as in the previous procedure to enable code entry.
2) Turn the small FMS Knob on the PFD to enter the first two code digits.
3) Turn the large FMS Knob to move the cursor to the next code field.
4) Enter the last two code digits with the small FMS Knob.
5) Press the ENT Key to complete code digit entry.
190-02622-00 Rev. A Garmin G1000 NXi Cockpit Reference Guide for the da62
Nav/Com/XPdR/audio
13