Garmin G1000 NXI Cockpit Reference Manual page 182

annunciations & alerts
System Message
NoN WGS84 WPT – Do not use
GPS for navigation to [xxxx]
PFd1 CaRd 1 ERR – Card 1 is
invalid.
PFd1 CaRd 1 REM – Card 1 was
removed. Reinsert card.
PFd1 CaRd 2 ERR – Card 2 is
invalid.
PFd1 CaRd 2 REM – Card 2 was
removed. Reinsert card.
PFd1 CoNFIG – PFD1 config
error. Config service req'd.
PFd1 CooLING – PFD1 has poor
cooling. Reducing power usage.
PFd1 dB ERR – PFD1 multiple
database errors exists.
PFd1 dB ERR – PFD1 obstacle
database missing.
PFd1 dB ERR – PFD1 terrain
database missing.
PFd1 KEySTK – PFD1 [key name]
is stuck.
PFd1 MaNIFEST – PFD1
software mismatch, communication
halted.
PFd1 SERVICE – PFD1 needs
service. Return unit for repair.
PFd1 VoLTaGE – PFD1 has low
voltage. Reducing power usage
PTK FaIL – Parallel track
unavailable: invalid leg type.
Garmin G1000 NXi Cockpit Reference Guide for the da62
158
Comments
The position of the selected waypoint [xxxx] is not calculated based
on the WGS84 map reference datum and may be positioned in error
as displayed. Do not use GPS to navigate to the selected non-
WGS84 waypoint..
The SD card in the top card slot of the specified PFD contains invalid
data.
The SD card was removed from the top card slot of the specified
PFD. The SD card needs to be reinserted.
The SD card in the bottom card slot of the specified PFD contains
invalid data.
The SD card was removed from the bottom card slot of the specified
PFD. The SD card needs to be reinserted.
The PFD configuration settings do not match backup configuration
memory. The system should be serviced.
The PFD is overheating and is reducing power consumption by
dimming the display. If problem persists, the system should be
serviced.
The PFD detected a failure in more than one database. Reload
databases with new data card. If problem persists, delete databases
and reload with a new card.
The obstacle database is present on another LRU, but is missing on
the specified LRU.
The terrain database is present on another LRU, but is missing on
the specified LRU.
A key is stuck on the PFD bezel. Attempt to free the stuck key
by pressing it several times. The system should be serviced if the
problem persists.
The PFD has incorrect software installed. The system should be
serviced.
The PFD self-test has detected a problem. The system should be
serviced.
The PFD1 voltage is low. The system should be serviced.
Invalid leg type for parallel offset.
190-02622-00 Rev. A