Garmin G1000 NXI Cockpit Reference Manual page 205

10) Press the device Softkey to view databases that are ready to be loaded from the mobile
device (pressing the Stby/actv Softkey will again display the current Standby and Active
databases).
11) The 'Aux - Databases' Page will show the databases connected to the mobile device in
place of the active databases on the system. Databases selected to load to the system
will be indicated by a single cyan arrow.
12) Press the Update Softkey.
13) If using a device that has not been previously paired with the system, a password prompt
will appear on the mobile device. Enter the password shown in the 'Password' Field of
the 'Aux - Connext Setup' Page.
14) Database Update status will appear in the 'Status' Window at the top of the page.
Monitor update progress in the 'Status' Window, or on the mobile device.
15) When all databases have been successfully transferred from the mobile device and appear
in the 'Standby' Column, remove and reapply power to the system.
16) Press the ENT Key or the right-most softkey on MFD display to acknowledge the startup
screen.
17) Turn the large FMS Knob and select 'Aux'.
18) Turn the small FMS Knob and select 'Databases'.
19) Verify that the standby databases transferred and are now in the 'Active' Column.
20) To manually activate any databases that did not transfer to the 'Active' Column:
a) Press the FMS Knob. The first database title on the screen will be selected.
b) Turn the small FMS Knob as necessary to select the database title.
c) Verify the correct database cycle information is shown for each database for each
display.
or :
Press the Menu Key and select 'Swap Standby and Active' using the small FMS Knob and
press the ENT Key. Press the ENT Key or the FMS Knob to exit.
d) Remove and apply power to the system.
e) Press the ENT Key or the right-most softkey on MFD display to acknowledge the
startup screen.
f) Turn the large FMS Knob and select 'Aux'
g) Turn the small FMS Knob and select 'Databases'.
h) Verify that the standby databases transferred and are now in the 'Active' column.
21) For additional information on each database, press and then turn the FMS Knob to select
the database, and then press the details Softkey. Press the ENT Key or the FMS Knob to
exit.
190-02622-00 Rev. A Garmin G1000 NXi Cockpit Reference Guide for the da62
.
appendix
181