Juicing System - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

JUICING SYSTEM

Problem
The juice collector
does not fit onto the
motor base.
You cannot close
the gap between
juice collector and
juicer cover.
You cannot fix the
locking arm in its
upper locked posi-
tion.
Reason
The pulp container is
not placed correctly
at the side of the
motor base.
Wrong orientation of
the juice collector.
The juicing sieve or
any other accessory
is still mounted on
the drive rotor.
The juicing sieve is
not engaged at the
drive rotor.
The pulp container is
not positioned cor-
rectly.
The juice collector
or juicer cover is not
mounted correctly.
The juicing sieve is
not locked to the
drive rotor correctly.
The Solution
Place the pulp container onto the pulp container protrusion at
the bottom of the motor base. If positioned correctly, it will fit
closely to the side of the motor base.
The juice spout of the juice collector must fit into the groove
at the motor base and the pulp guttering must fit into the pulp
container. Position the juice collector accordingly.
Remove any accessories from the drive rotor. The juice collector
is always mounted BEFORE inserting the juicing sieve.
Remove the juicer cover. Turn the juicing sieve without pressure
over the drive rotor until the juicing sieve slides down easily.
Then push down the juicing sieve slightly to make it engage
tangibly on the drive rotor.
Place the pulp container on the protrusion at the bottom of the
motor base. Otherwise, the pulp spout of the juicer cover cannot
slide into the pulp container.
Ensure that the juice collector and juice cover are mounted tight-
ly and without any gaps.
Remove the juicer cover and turn the juicing sieve to and fro on
the drive rotor until it slides down. Then push the juicing sieve
down gently. It must engage tangibly on the drive rotor. The-
reafter mount the juicer cover again. There may be no gap bet-
ween juicer cover and juice collector. Try again.
117