Emptying The Containers And Removing Obstacles - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

Important: During operation, ensure that the juice is running into the juice jug and
the pulp is falling freely into the pulp container. Otherwise, check the juicing sys-
tem for obstacles (see: 'Emptying the Containers and Removing Obstacles' and
'Solving Problems').
7. After juicing, turn the selection dial to "OFF", switch the power switch to "O",
and wait until the motor stops. Unplug the appliance. Remove the juicing system
from the motor base (see: 'Disassembling the Juicing System').
8. Empty and rinse the containers of the appliance and all parts of the juicing sys-
tem immediately after juicing. Then clean all used parts (see: 'Cleaning the Jui-
cing System').
Note
Do not store juices and pulp in the containers of the appliance to avoid that food
dries on the surfaces. Additionally, some food may cause discolouration. For sto-
rage, fill the products into sufficient containers and clean the containers of the
appliance immediately thereafter. Pulp and juices may be stored in the refrigera-
tor for 1 day at the maximum. However, for always getting the optimum benefits
of vitamins and other valuable nutrients, it is best to always freshly prepare and
consume your juices.

EMPTYING THE CONTAINERS AND REMOVING OBSTACLES

During juicing, ensure that the juice is running into the juice jug and the pulp is falling
freely into the pulp container. Ingredients containing a lot of hard fibres could easily
clog the juicing sieve, especially when applying hard pressure to the food pusher
during juicing. Additionally, fine residues of the pulp could clog the juice collector
or the juice spout, causing overflow. If you push down the food in the feed chute
too fast, the juicing sieve could be overfilled too.
In these cases, you need to empty the juice collector and juicing sieve and clean the
juice mesh of the juicing sieve, before you can continue operation. For this, follow
the instructions in this section and see also: 'Solving Problems'.
1. Turn the selection dial to the "OFF" position (display gets dark), switch off the
appliance at the power switch, wait until the motor stops, and unplug the appli-
ance.
WARNING:
Always handle the juicing sieve by the rim or dark drive coupling.
104
The blades in the base plate of the juicing sieve are very sharp.