Storage - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

Remove the sealing ring from the blade assembly. To get an easy grip on the
sealing ring, hold the blade assembly with the blades facing downwards.
Note
If there are stubborn residues on the surfaces, you should soak the parts for approx.
10 minutes in warm dishwater.
3. Clean the used parts (lid, ingredients cup, scraper, glass container, sealing ring,
blade assembly) in warm dishwater using a soft nylon brush. Especially the bla-
de assembly may be cleaned by brushing. For this, hold the blade assembly
by the collar. Stubborn residues can be removed easily from the parts, after
soaking in lukewarm dishwater for approx. 10 minutes.
4. Rinse with clear tap water and wipe dry, ensuring not to touch the knives of the
blade assembly with your hands. Leave the parts dry naturally for approx. 30
minutes, where they are out of reach of young children.

STORAGE

WARNING:
appliance or any part of it. When the appliance is not in use, always turn the
selection dial to the "OFF" position, switch off the power switch, and unplug the
appliance. Do not leave the motor base connected to the power supply, while
it is not in use.
Do not hold the appliance by the power cord, drive rotor, locking arm, or any
part of the processing system for moving the appliance to avoid damage. Instead,
grasp the motor base at both sides. The power cord may never be knotted, twi-
sted, pulled, strained or squeezed. Do not let the plug or power cord hang over
the edge of the table or board. Always handle the glass containers of the optio-
nal accessories (mixing jug, mincing jug, grinding cup) with special care to avoid
damage.
Do not place any hard or heavy objects on or in the appliance or any part of it.
Do not use any parts or accessories of the appliance for any other appliance or
any other purpose than described in this booklet.
1. Please store the appliance in a frost free, clean and dry place where it is pro-
tected against excessive load (e.g. mechanical or electric shock, heat, direct
sunlight) and out of reach of young children.
2. Clean the appliance and all parts before storing (see: 'Care and Cleaning'). For
storage, you may loosely wind the power cord around the cord storage at the
bottom of the motor base.
Children must be supervised that they do not play with the
129