Grinding Dry Food (Optional Accessory) - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

and reduce the amount of food in the glass jug by processing your food in smal-
ler portions. It could be helpful to process your food in short pulses—at least until
your food is cut to sufficiently small pieces by the knives of the blade assembly.
Removing the Glass Jugs after Operation
16. Ensure that the selection dial is turned to "OFF" and the power switch is switched
off. Wait until the motor stops. Then unplug the appliance.
CAUTION:
before removing the glass jug. DO NOT turn the processing system by the glass
jug but always grasp the collar of the blade assembly. Otherwise, the connec-
tion of glass jug and blade assembly may be loosened and your foodstuffs will
run out.
17. Grasp the blade assembly by the collar and turn it counter-clockwise to unscrew
it from the motor base. Then remove the used system from the motor base.
18. Remove your food from the glass jug and clean the used parts (see: 'Care and
Cleaning').

GRINDING DRY FOOD (OPTIONAL ACCESSORY)

Dry food (e.g. dried herbs, spices, seeds, nuts, coffee beans, sugar) can be pulve-
rized or granulated using the grinding system.
WARNING:
ling, hold the grinding blades by the collar.
Risk of Explosion! When opening the grinding system after operation, avoid
open fire near your working space (e.g. candles, cigarettes, barbecue fire).
Fine, swirled up dust (e.g. pulverized sugar, flour) could catch fire and explo-
de, when coming in contact with open fire.
Always ensure that the grinding cup is undamaged, before operation. There may be
no cracks and chipped edges. Even small splinters could cause severe injuries when
getting into your food or beverages. Additionally, chipped edges or any dried on
food at the thread and/or sealing area of the grinding cup, sealing ring, or blade
assembly could cause leakage and damage.
Before placing the grinding system on the motor base, always ensure that the exteri-
or of the grinding system (especially the bottom of the blade assembly) is completely
clean to avoid leakage and damage to the motor base.
110
Always wait until the motor comes to a complete standstill,
The knives of the grinding blades are very sharp. For hand-