Disassembling The Optional Accessories; Cleaning The Motor Base - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

3. Push the locking arm out of the support on the juicer cover and lower the locking
arm to the horizontal position.
4. Lift the juicer cover upwards to remove it.
5. Lift the juice collector upwards too. You will notice a slight resistance caused
by the drive coupling, because the juicing sieve will come out together with the
juice collector.
6. Take the pulp container away from the motor base and empty the pulp container.
7. Clean the parts of the juicing system always after operation. Do not leave any
food dry on the surfaces (see: 'Cleaning the Juicing System').

DISASSEMBLING THE OPTIONAL ACCESSORIES

For cleaning the mixing system or mincing system you may use the self-cleaning fea-
ture. For this, you do not need to disassemble the glass jug. However, when there
are still any residues of food on the surfaces the glass jug, sealing ring, or blade
assembly, you should clean the parts of the system separately (see: 'Cleaning the
Optional Accessories').
The grinding system must be disassembled anyway for getting out your food. Thus,
there is no benefit of performing a self-cleaning procedure. Always clean the parts
of the grinding system according to the instructions in section 'Thorough Cleaning
and Removing Stubborn Residues'.

CLEANING THE MOTOR BASE

1. After operation, always turn the selection dial to the "OFF" position, switch OFF
the appliance at the power switch (position "O"), then unplug the appliance.
2. Remove the used processing system from the motor base (see: 'Disassembling
the Juicing System', 'Removing the Glass Jugs After Operation').
CAUTION:
liquids onto the motor base. Do not use any hard objects to avoid damage to the
safety interlocks and surfaces.
3. Wipe the exterior of the motor base and power cord with a slightly damp, soft
cloth, removing any residues of splashes. Ensure that no liquids will run on or
under the motor base.
4. Polish with a soft dry cloth and leave dry naturally for approx. 30 minutes, where
the motor base is out of reach of young children.
Always keep the motor base dry. Avoid spilling or dripping any
125