Assembling The Grinding System (Optional Grinding System); Operation - Gastroback DESIGN MULTI JUICER DIGITAL Operating Instructions Manual

Note
If the motor does not start, when switching on and selecting a speed level, probab-
ly the safety interlocks are not engaged. These features of the appliance ensure
that the processing system is locked firmly to the motor base and probably leak-
free, thus protecting you from harm and damage. Check, if the threads are scre-
wed on sufficiently tight (see: 'Solving Problems').
ASSEMBLING THE GRINDING SYSTEM (OPTIONAL GRINDING
SYSTEM)
In any case, the grinding system must be filled, before assembling the grinding
blades. The grinding cup will be closed air-tight, after screwing on the grinding
blades (see: 'Operation / Grinding Dry Food').

OPERATION

WARNING:
ries are out of reach of young children. Handle the juicing sieve and blade
assemblies (optional accessories) with special care, because the integrated knives
are very sharp.
Optional accessories: The glass containers are fragile. Always handle with care.
Do not fill in any hot food or liquids! Even small splinters and shards could cau-
se severe injuries, when getting into your food. Thus, before using the optional
accessories, always ensure that the glass parts are completely undamaged. There
may be no cracks, or chipped edges.
Switch off completely (selection dial to "OFF", power switch to "O"), wait until the
motor stops, and unplug the appliance, before assembling or disassembling any
parts, and when the appliance is not in use. Do not leave the motor base unat-
tended, while it is connected to the power supply. Do not overfill the containers of
the processing systems (pulp container, juice jug, glass jugs, grinding cup) to avo-
id overflow. During juicing, ensure that the juices will run into the juice jug without
obstacles. Otherwise, the juice could run on or under the motor base due to overflow
of the juice collector.
If any liquids run out during operation or are accumulating under the motor base,
immediately unplug the appliance and carefully remove the processing system from
the motor base. Then clean and dry the motor base (see: 'Care and Cleaning').
Leave the motor base dry naturally for at least 1 day. Use some water for checking
the used processing system for leakage (see: 'Solving Problems').
Always ensure that the appliance and all its parts and accesso-
101