Section 2: To The Operator - Taylor C706 Operator's Manual

Section 2
The Model C706 has been carefully engineered and
manufactured to give you dependable operation.
This machine, when properly operated and cared for, will
produce a consistent quality product. Like all mechanical
products, it requires cleaning and maintenance. A
minimum amount of care and attention is necessary if the
operating procedures outlined in this manual are
followed.
IMPORTANT! This manual should be read
before operating or performing any maintenance on your
machine.
Your Taylor freezer will not eventually compensate for
and correct any errors during the setup or filling
operations. Thus, the initial assembly and priming
procedures are of extreme importance. It is strongly
recommended that personnel responsible for the
equipment's operation, both assembly and disassembly,
go through these procedures together in order to be
properly trained and to make sure that no confusion
exists.
If you should require technical assistance, please contact
an authorized Taylor distributor.
Note: Your Taylor warranty is valid only if the parts are
authorized Taylor parts, purchased from the local
authorized Taylor distributor, and only if all required
service work is provided by an authorized Taylor service
technician. Taylor reserves the right to deny warranty
claims on machines or parts if parts not approved by
Taylor or incorrect refrigerant were installed in the
machine, system modifications were performed beyond
factory recommendations, or it is determined that the
failure was caused by abuse, misuse, neglect, or failure
to follow all operating instructions. For full details of your
Taylor Warranty, please see the Limited Warranty section
in this manual.
IMPORTANT! If the crossed-out wheeled-bin
symbol is affixed to this machine, it signifies that this
machine is compliant with the EU Directives as well as
To the Operator
other similar end-of-life legislation in effect after August
13, 2005. Therefore, it must be collected separately after
its use is completed and cannot be disposed as unsorted
municipal waste.
The user is responsible for delivering the machine to the
appropriate collection facility, as specified by your local
code.
For additional information regarding applicable local
disposal laws, please contact the municipal waste facility
and/or local authorized Taylor distributor.
The user is responsible for returning the product to the
appropriate collection facility, as specified by your local
code. For additional information regarding applicable
local laws, please contact the municipal facility and/or
local distributor.
Model C706
To the Operator
2
2-1