Air/Mix Pump Checklist; Winter Storage - Taylor C706 Operator's Manual

OPERATOR'S CHECKLIST
 If your machine is equipped with an auxiliary
refrigeration system, check the auxiliary
condenser for accumulation of dirt and lint. Dirty
condensers reduce the refrigeration capacity of
the mix hopper. Condensers must be cleaned
monthly with a soft brush. Never use screwdrivers
or other metal probes to clean between the fins.
 If your machine is water-cooled, check the water
lines for kinks or leaks. Kinks can occur when the
machine is moved back and forth for cleaning or
maintenance purposes. Deteriorated or cracked
water lines should be replaced only by an
authorized Taylor service technician.

Air/Mix Pump Checklist

 Dispose of O-rings and valve gaskets if they are
worn, torn, or fit too loosely. Replace them with
new ones.
 Handle plastic pump parts with care to avoid nicks
and cracks.
 Make sure the air/mix pump is properly attached
to the drive hub, or severe and costly damage
may occur.
7
7-2

Winter Storage

If the place of business is to be closed during the winter
months, it is important to protect the freezer by following
certain precautions, particularly if the building is subject
to freezing conditions.
Disconnect the freezer from the main power source to
prevent possible electrical damage.
On water-cooled freezers, disconnect the water supply.
Relieve pressure on the spring in the water valve. Use air
pressure on the outlet side to blow out any water
remaining in the condenser.
Important! Failure to follow this procedure may cause
severe and costly damage to the refrigeration system.
Your local Taylor service technician can perform this
winter storage service for you.
Wrap detachable parts of the freezer, such as the beater,
blades, driveshaft, and freezer door, and place them in a
protected, dry place. Rubber trim parts and gaskets can
be protected by wrapping them with moisture-proof
paper. All parts should be thoroughly cleaned of dried mix
or lubrication, which attract mice and other vermin.
Model C706
Operator's Checklist