Pch-Fw Configuration; Power Management - Aaeon MIX-H310D1 Manual

[*Active*] Serial Port 2
Use this device [Enabled]
Allows you to enable or disable this logical device. Configuration options:
[Enabled] [Disabled]
Possible [Use Automatic Settings]
This item appears only when you set Use this device to [Enabled] and
allows you to select an optimal setting for Super I/O devices. Configuration
options: [Use Automatic Settings] [IO=3E8h; IRQ=7] [IO=3F8h; IRQ=4;]
3.3.7 PCH-FW Configuration
The items listed in this screen display firmware related information.
Firmware Update Configuration
Me FW Image Re-Flash [Disabled]
Allows you to enable or disable Me firmware Image Re-Flash function.
Configuration options: [Disabled] [Enabled]
Local FM Update [Enabled]
This item allows you to enable or disable Local FM Update function. Configuration
options: [Disabled] [Enabled]
3.3.8

Power Management

Power Mode [ATX Type]
Select power supply mode. Configuration options: [ATX Type] [AT Type]
The following items appear when you set Power Mode to [ATX Type].
Restore AC Power Loss [Last State]
[Last State] The system goes into either off or on state, whatever the system
state was.
[Always On] The system goes into on state after an AC power loss.
[Always Off] The system goes into off state after an AC power loss.
RI Wake Event [Disabled]
Enable or disable system to wake up from RI#. Configuration options: [Enabled]
[Disabled]
Chapter 3: BIOS setup
3-9