Pch-Fw Configuration; Sio Configuration - Aaeon MIX-KLUW1 Manual

3.3.5 PCH-FW Configuration
Firmware Update Configuration
Me FW Image Re-Flash [Disabled]
This item allows you to enable or disable Me FW Image Re-Flash function.
Configuration options: [Disabled] [Enabled]
3.3.6 SIO Configuration
The items in this menu allow you to configure Super I/O settings.
[*Active*] Serial Port 1
Use this device [Enabled]
Allows you to enable or disable this logical device. Configuration options:
[Enabled] [Disabled]
The following two items appear only when you set Use this device to
[Enabled].
Possible [Use Automatic Settings]
Allows you to select an optimal setting for Super I/O devices. Configuration
options: [Use Automatic Settings] [IO=3F8h; IRQ=4;] [IO=2F8h; IRQ=3]
Mode [RS232]
Allows you to select the Serial Port mode. Configuration options: [RS232]
[RS422] [RS485(Receiver Half Duplex)]
[*Active*] Serial Port 2
Use this device [Enabled]
Allows you to enable or disable this logical device. Configuration options:
[Enabled] [Disabled]
The following two items appear only when you set Use this device to
[Enabled].
Possible [Use Automatic Settings]
Allows you to select an optimal setting for Super I/O devices. Configuration
options: [Use Automatic Settings] [IO=3F8h; IRQ=4;] [IO=2F8h; IRQ=3]
Chapter 3: BIOS setup
3-5