Table of Contents
Advertisement
The following two items appear only when you set Use this device to
[Enabled].
Possible [Use Automatic Settings]
Allows you to select an optimal setting for Super I/O devices. Configuration
options: [Use Automatic Settings] [IO=3E8h; IRQ=7;] [IO=3F8h; IRQ=4]
3.3.7
AMT Configuration
AMT BIOS Features [Enabled]
When disabled, you are not able to access the MEBx setup. Configuration options:
[Enabled] [Disabled]
This option does not disable manageability features in the firmware.
3.3.8
PCH-FW Configuration
Firmware Update Configuration
Me FW Image Re-Flash [Disabled]
This item allows you to enable or disable Me FW Image Re-Flash function.
Configuration options: [Disabled] [Enabled]
3.3.9
Power Management
Power Mode [ATX Type]
Select power supply mode. Configuration options: [ATX Type] [AT Type]
The following items appear when you set Power Mode to [ATX Type].
Restore AC Power Loss [Last State]
[Last State]
The system goes into either off or on state, whatever the system
state was.
[Always On]
The system goes into on state after an AC power loss.
[Always Off]
The system goes into off state after an AC power loss.
RI Wake Event [Disabled]
Enable or disable system to wake up from RI#. Configuration options: [Enabled]
[Disabled]
RTC Wake system from S5 [Disabled]
[Disabled]
[Fixed Time]
[Dynamic Time]
Chapter 3: BIOS setup
Disables system wake up from S5.
The system will wake up at the specified hr::min::sec.
Configuration options: [Disabled] [Enabled] .
The system will wake up at the current time plus a specified
number of minutes.
3-7
Advertisement
Table of Contents
