Table of Contents
Advertisement
Selenio™ Network Processor
User Guide
Program Configuration: Output Tab
There is always the option to output to IP. If the input is IP, then SDI output is automatically enabled. If
the input is using the SDI connector, then the SDI output options,
SDI Audio Embedder (Output Tab)
IP output settings are always present on this tab. See the following topics:
•
IP Video Configuration (Output Tab)
•
IP Video Status (Output Tab)
•
IP Audio Configuration (Output Tab)
•
IP Audio Status (Output Tab)
•
IP Ancillary Data Configuration (Output Tab)
•
IP Ancillary Data Status (Output Tab)
HD Proxy options also appear on this tab. See
and
Proxy IP Video Status (Output Tab)
Pixel Format (Output Tab)
UHD Quad Output Pixel
Format Select
UHD Output Pixel Format
Used
SDI (Output Tab)
SDI Output
© 2019 Imagine Communications Corp.
(on page 117) will not appear.
(on page 117)
(on page 118)
(on page 119)
(on page 120)
(on page 120)
(on page 121)
Proxy IP Video Configuration (Output Tab)
(on page 119). HD Proxy video is always sent over IP.
If the output is UHD, this selection determines how output video is
interpreted:
•
Square Division
•
Pixel Interleave
The Square Division option is only available when the Output Mode is SDI.
This selection only has an effect when using Quad outputs; 12G is always
interleave.
This read-only parameter indicates what pixel format is being output:
•
Square Division
•
Pixel Interleave
Displays Enabled if the input is set to IP.
Proprietary and Confidential.
Configuring Programs
SDI (Output Tab)
(on page 116) and
May 2019 | Page 116
(on page 118)
Advertisement
Table of Contents
