Table of Contents
Advertisement
Selenio™ Network Processor
User Guide
IP Address
UDP Port
Routing Control
Number of Channels
Channel Select (1 - 8)
IP Audio Status (Output Tab)
Options in this section appear separately for Primary and Secondary.
Destination MAC Address
IP Ancillary Data Configuration (Output Tab)
Data Stream
The following parameters can be set for both Primary and Secondary.
ANC Data IP Transmitter
Enable
WAN Select
IP Address
UDP Port
© 2019 Imagine Communications Corp.
Set the address of the destination IP device.
(User Datagram Protocol) Use this field to set the destination port number.
The range is 1 to 65535.
Determines the number of channels in this audio stream, which can be
from 1 to 8. The default is 2. For ST2110-31, must be a multiple of 2.
Selects the source for the specified audio channel in this RTP stream.
Note: There will be as many channels to select as Number of Channels
defined above.
This read-only parameter reports the MAC address of the receiver's
primary or secondary SFP+ port. If no destination is using this IP
Transmitter's Destination IP Address, the parameter reports the DST
unreachable.
Choose the data stream (1 - 4) to configure. The rest of the parameters in
this section will then apply to that stream.
Enables the data IP transmitter for this stream.
Use this parameter to set the source WAN IP address for transmitting this
IP Transmitter's data. Possible options are WAN 1 to WAN 4.
This field also displays the IP address and VLAN defined in the Element's IP
WAN menu.
Set the address of the destination IP device.
(User Datagram Protocol) Use this field to set the destination port number.
The range is 1 to 65535.
Proprietary and Confidential.
Configuring Programs
May 2019 | Page 120
Advertisement
Table of Contents
