Table of Contents
Advertisement
Selenio™ Network Processor
User Guide
LED Name
Alarm
Back Panel
The back panel for both SNP-GW-3GX32 and SNP-GW-3GX32-HS-QF has the same layout:
Item Description
1
IEC power inlets; see
2
Ground pin (10/32 or metric M5/standard)
3
QSFP100 Flexible Ethernet I/O
• 100 GBE
• Main and Protect, full 2022-7
• Can be used for PTP timing slave for synchronization; See
26).
4
SFP+ sockets; support SDI-on-fiber and MADI SFP; for future use
5
GPIO/RS-232, for future use
6
Dual 1G Management Ethernet ports; see Initial Setup (on page 26)
7
Analog reference input (for future use) and analog black burst reference output generated from
the PTP signal; see Configuring Reference for SNP (on page 53).
8
SDI inputs/outputs:
• Amphenol HD-BNC (8 groups of 4) 8xUHD or 32xHD
• 12-G capable BNC of each quartet is labeled with a square of the opposite color
© 2019 Imagine Communications Corp.
Condition Indicated
• Green—No major or minor alarms
• Amber—Only minor alarms
• Red—Major alarms
• Off—System is not ready
Note: Alarms disabled in the UI do not affect the alarm LED.
Electrical Requirements
Proprietary and Confidential.
(on page 22)
Connecting to a PTP Source
Introduction
(on page
May 2019 | Page 19
Advertisement
Table of Contents
