Table of Contents
Advertisement
Selenio™ Network Processor
User Guide
When you are done, click Apply Sections and reboot the SNP.
Note: A reboot is required to change a processor's mode between HD and UHD.
Configuring for Unicast
You will need to configure both the transmitting and receiving devices.
To configure the transmitting SNP:
1. Open the Configure Processor dialog box for the Program that will be transmitted.
2. On the Output tab, enter the Primary IP address on the Primary WAN of the remote device, and the
Secondary IP address on the Secondary WAN of that same device.
3. Enter a number for the Primary and Secondary UDP port.
Normally these will be the same number.
© 2019 Imagine Communications Corp.
UHD Processor (1 program)
HD Processor (4 programs)
Proprietary and Confidential.
Configuring Processors
May 2019 | Page 90
Advertisement
Table of Contents
