Selenio™ Network Processor
User Guide
WAN Select
IP Address
UDP Port
Proxy IP Video Status (Output Tab)
These settings are for the HD Proxy transmission channels. Parameters in this section appear for both
Primary and Secondary.
Destination MAC Address
IP Audio Configuration (Output Tab)
Audio Stream
Audio IP Transmitter Enable
Transmitter Mode
Bit Width
The following parameters can be set for both Primary and Secondary.
WAN Select
© 2019 Imagine Communications Corp.
Use this parameter to set the source WAN IP address for transmitting this
IP Transmitter's data. Possible options are WAN 1 to WAN 4.
This field also displays the IP address and VLAN defined in the Element's IP
WAN menu.
Set the address of the destination IP device.
(User Datagram Protocol) Use this field to set the destination port number.
The range is 1 to 65535.
This read-only parameter reports the MAC address of the receiver's
primary or secondary SFP+ port. If no destination is using this IP
Transmitter's Destination IP Address, the parameter reports the DST
unreachable.
Choose the audio stream (1 - 16) to configure. The rest of the parameters
in this section will then apply to that stream.
Enables the audio IP transmitter for this stream.
Configures the operational mode of the transmitter on this stream.
Options include:
• ST2110-30
Sets the sample bit width for this audio transmitter stream. Options are:
•
16 bits
•
24 bits
Use this parameter to set the source WAN IP address for transmitting this
IP Transmitter's data. Possible options are WAN 1 to WAN 4.
This field also displays the IP address and VLAN defined in the Element's IP
WAN menu.
Proprietary and Confidential.
Configuring Programs
May 2019 | Page 119