Table of Contents
Advertisement
Selenio™ Network Processor
User Guide
SDI UHD Output Link Select
SDI Audio Embedder (Output Tab)
Note: These options only appear when SDI output is enabled (above).
General Config
ADS Clean
Grp (1 - 4) Pair (1 - 2) Control
General Status
Grp (1 - 4) Append Error
Grp (1 - 4) OverWrite Error
IP Video Configuration (Output Tab)
Video IP Transmitter Enable
Transmitter Mode
Packing Mode
© 2019 Imagine Communications Corp.
Determines which SDI output to use. Options will vary depending on
whether the processor is in Conversion, Sync, or Remap mode.
1st Link (TL) top left
2nd Link (TR) top right
3rd Link (BL) bottom left
4th Link (BR) bottom right
UHD (Quad Link) (convert only)
UHD (12G) Across all personalities except Sync when in HD mode, 1st BNC
Clears the audio data space before embedding.
Enables embedding of the selected pair in the audio group. By default all
groups are enabled.
Read-only parameter that indicates whether there is an append error on
the specified embedder group.
Read-only parameter that indicates whether there is an overwrite error on
the specified embedder group.
Enables this transmitter.
Configures the operational mode of this transmitter. Options are:
•
ST 2110-20
•
ST2022-6 (only available when the standard is HD)
Selects either General packing mode (GPM) or Byte packing mode (BPM).
GPM is the default.
This parameter is only available when the Transmitter Mode (above) is set
to ST 2110-20.
Proprietary and Confidential.
Configuring Programs
May 2019 | Page 117
Advertisement
Table of Contents
