Table of Contents
Advertisement
Selenio™ Network Processor
User Guide
Dual Conversion
UHD Remap
SNP contains four processors. Each processor can take on any personality.
Configuring a Sync Personality
When using the SNP Sync personality, the input and output video will have the same standard. Each
processor has two sections that are independently selectable to be (one) UHD or (four) HD streams. See
Configuring a Section for HD or UHD
When mapped entirely for HD, a SNP will have a maximum of 32 HD programs. Each of the 32 BNCs on
the back panel of SNP is one-to-one mapped to one HD channel specifically. See
for more information.
The input can be SDI or IP, and the output can be SDI and IP concurrently (if the input is not SDI).
Configuring IP to SDI/IP
Ensure that the IP WAN has been configured before setting up any receivers, and that your SNP is
configured for Sync personality.
To configure a SNP program as receiving video from IP input, and transmitting it out as SDI, follow these
steps:
1. Choose the Section Input mode as IP for the section of the processor you're working on.
2. Click the Program you want to configure.
3. On the Input tab, make WAN-related configurations as appropriate for your network, including the
following:
▪
Check the "Video IP Receiver Enable" checkbox.
▪
Set the correct Receiver Video Standard.
▪
Set the Primary and Secondary WAN selects.
▪
Set the Primary IP address, UDP port, and (optional) multicast source.
▪
Set the for secondary IP address, UDP port, and (optional) multicast source.
© 2019 Imagine Communications Corp.
2 Conversions
(Up/Down/Cross)
2 Channels
(on page 89).
Proprietary and Confidential.
Configuring Processors
8 Conversions
8 Channels
BNC Ports
(on page 20)
May 2019 | Page 81
Advertisement
Table of Contents
