Command Line Functions - Optical Systems Design OSD2184P Operator's Manual

2.4.2

COMMAND LINE FUNCTIONS

There are a number of command line functions that enables the user to obtain limited information or
reset the unit to factory default configuration.
Once the terminal emulation has been set up typing the "?" command will bring up a list of available
CLI commands.
The following table outlines the user available command line commands and their functions.
TERMINAL
COMMAND SPECIFICATION
LINE
? help
vc Version Check
Dump PD
poe_dump
Information
ipconfig IP Configuration
ds Default Setting
PAGE 22
OPTICAL SYSTEMS DESIGN
FIGURE 14: CLI "?" COMMAND
TABLE 8: CLI COMMAND LIST
Displays all user available CLI commands
Displays the current software version and
revision installed on the unit
Displays the running PoE Information for
each Port/Channel
Displays current IP, Mask and Gateway.
Provides ability to change the IP settings.
Allows the user to reset the unit to factory
default.
OSD2184P OPERATOR MANUAL
FUNCTION
DOC ID: 10119601
FIGURE
Figure 14
Figure 15
Figure 16
Figure 17
Figure 18