Table of Contents
Advertisement
5.
Section name and functions
Camera / Tripod adaptor
mounting screw holes
Lens mount
（C mount）
Camera / Tripod adaptor
mounting screw holes
6.
Camera mounting (Attention Hot!)
This camera has high data rate for high frame rate. A camera chassis will become a very high temperature by high data rate.
Please be careful about handling so that you don't get burned.
Please don't touch the camera a power supply is supplied with. Please wait a moment until a camera gets cold after stopping
supply of a power supply.
When doing the handling which touches a camera, a heat sink is needed.
The heat sink size : Like a size of t10mm x 135mm x 135mm by aluminum plate.
7.
Lens
CAUTION
Observe the dimensions of the lens mounting selection as
illustrated at the right.
If the dimensions are not observed, do not use such a lens,
because the lens and the camera will be damaged.
Selecting a lens
The proper lens is important for obtaining adequate performance from the camera.
Especially in the case of a three elements CCD system C mount camera, the lens
incidence and exit distances are important. If separation is too short, color
irregularity Is apt to occur at the top and bottom of the image.
Conversely if too long, where the lens iris is a nearly fully open, resolution is
impaired, while shading and flare can seriously detract from image quality. When
using 3 CCD color system camera, it is also recommended to use a lens designed
for this purpose.
CameraLink connectors
Use for digital video output
and camera control signal
input/output signal.
Pilot lamp
It lights up when power
supply.
DC IN/SYNC connector
Use for DC+12V power or external
trigger / VD signal input or Flash /
VD output
Lens optics
Lens flange
Max 4mm
4
Advertisement
Table of Contents
