Table of Contents
Advertisement
GENERAL ASSEMBLY INSTRUCTIONS
1
5b
10
15
WARNING:
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM. TO REDUCE
THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed
on page 7 (Fig. 4).
5. Insert the steel rod into the hose storage rack, and snap into place. Make sure the buttons on
the rod are directed as illustrated (Fig. 5a & 5b).
6. Locate the two openings on the bottom of the wall mount rack and insert the wire accessory
storage into the wall mount until they lock in place. Make sure the wire accessory storage is
directed towards the front side of the wall mount rack (Fig. 6).
7. Insert the steel rod with hose storage rack into the two holes located on the top of the wall
mount rack. Ensure the Vacmaster logo is facing forward (Fig. 7).
2
3
6
11
12
16
17
DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
4
7
8
13
18
8
5a
9
14
19
Advertisement
Table of Contents
