Table of Contents
Advertisement
Conforms to UL
Standard UL1017
Certified to CSA STD
C22.2 No.243-10
Owner's Manual
This unit is intended for commercial use.
8 Gallon Industrial (Commercial)
Wet/Dry Vacuum
With Certified HEPA Filtration
Model No. VK811PH
FOR YOUR SAFETY
Read and understand this manual before use.
Keep this manual for future reference.
®
www.vacmaster.com
Cleva North America, Inc.
Greenville, SC 29607
866-384-8432
HEPA Vacuums
MNL_VK811PH_V2
Advertisement
Table of Contents
Related Manuals for Vacmaster VK811PH
Summary of Contents for Vacmaster VK811PH
- Page 1 Owner’s Manual This unit is intended for commercial use. 8 Gallon Industrial (Commercial) Wet/Dry Vacuum With Certified HEPA Filtration Model No. VK811PH FOR YOUR SAFETY Read and understand this manual before use. Keep this manual for future reference. www.vacmaster.com Cleva North America, Inc.
-
Page 2: Table Of Contents
Contact Vacmaster at 866-384-8432 for any warranty inquiries. Do not return a failed unit to the place of purchase or service center. Any charges for the shipping of a Vacmaster unit under warranty are purchaser’s responsibility unless Vacmaster requests such return in writing. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. -
Page 3: Safety Instructions And Warnings
• To reduce the risk of falls, use extra care when cleaning on stairs. • When using for HEPA EPA RRP cleanup tasks, use only certified Vacmaster HEPA filter. • Even when used with a HEPA filter, extremely small particles may pass through the filter, always wear appropriate protective safety equipment. -
Page 4: Double Insulation Instructions
DOUBLE INSULATION INSTRUCTIONS This HEPA Vac is double-insulated, eliminating the need for a separate grounding system. Use only identical replacements parts. Read the instructions for Servicing Double-Insulated Wet/Dry Vacs before servicing. Use this Wet/Dry Vac as described in this manual. Observe the following warnings that appear on the motor housing of your Wet/Dry Vac. -
Page 5: Extension Cord
EXTENSION CORDS When using an extension cord with your Wet/Dry Vac refer to the following table to determine the required A.W.G. wire size. Before using the cleaner make sure the power cord and extension cord are in good working conditions. Make repairs or replacements before using the vacuum cleaner. Only use extension cords that are rated for outdoor use. -
Page 6: Unpacking And Checking Carton Contents
UNPACKING AND CHECKING CARTON CONTENTS Remove entire contents of carton. Check each item against the carton contents list. Carton contents lists Description ........QTY. Vac Assembly........1 Crevice Nozzle ........1 Extension Wands (1) ......1 Extension Wands (2) ......1 Air Regulator Handle ......1 Hose ............1 Floor Squeegee........1 Horse Hair Round Brush .....1... -
Page 7: General Assembly Instructions
GENERAL ASSEMBLY INSTRUCTIONS A Philips head screw driver is required. WARNING: DO NOT PLUG IN POWER CORD TO POWER OUTLET, MAKE SURE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC. The hepa vacuum is supplied with a certified hepa filter that Has been lot tested by independent lab to IEST-RP-CC001 that meet the epa definition of a hepa vacuum (100% leak tested to 99.97% @ 0.3 micron Efficiency). -
Page 8: Dry Vacuuming Operation
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBL 1. Verify that the power cord is disconnected from the outlet. (fig. 1) 2. Undo the latches. (fig. 2) 3. Lift the power head off the tank. (fig. 3) 4. Remove the contents from inside the tank, make sure you have all contents as listed on page 6. (fig. - Page 9 WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS.
-
Page 10: Liquid Vacuuming Operation
LIQUID VACUUM OPERATION LIQUID VACUUMING WARNING: BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION, ENTITLED ‘SAFETY INSTRUCTIONS & WARNINGS’. DO NOT VACUUM IN AREAS WITH FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO; LIGHTER FLUID, SOLVENT TYPE CLEANERS, OIL-BASE PAINTS, GASOLINE, ALCOHOL OR AEROSOL SPRAYS. -
Page 11: Maintenance
is fitted with a float valve that stops the suction action when the container reaches its maximum capacity. You will notice an increase in motor speed. When this happens, turn off the machine, disconnect from power supply, and drain the liquid into a suitable receptacle or drain. To continue vacuuming, refit the container with the drain cap. -
Page 12: Installing & Cleaning Foam Sleeve Filter
Installing HEPA Filter and Pre-Filter 1. Verify that the power cord is disconnected from the outlet. (fig. 1) 2. Remove power head and place in upside down position. 3. Install the HEPA filter over the filter cage with the flat end of the filter towards the vacuum power head. -
Page 13: When To Change Filters
WHEN TO CHANGE FILTERS Change the collection bag When the collection bag is 3/4 full, it MUST be replaced. Excessive over filling of this bag makes it difficult to remove from the vacuum tank and can result in breakage and spills. The collection bag comes equipped with a quick closing flap. -
Page 14: Parts -Exploded View
PARTS -EXPLODED VIEW VK811PH Manual Parts List Drawing Number Description Quantity Drawing Number Description Quantity Key Number Key Number VK01SR.A0.01 Handle Assembly T0DXL1.65.UL Inner Cable Top Cover Tank VK21SR.A0.04 VK30PW.11.00 Switch Latch Assembly W0DQ10.01.12 TVQTDK.05.00 VK21SR.10.06 Filter Sponge TVQTXK.A0.03 Suction Assembly VK30SR.A0.01... - Page 15 NOTES...