Table of Contents
Advertisement
1
EMPTYING THE COLLECTION TANK
WARNING:
BEFORE REMOVING THE POWER HEAD FROM COLLECTION TANK.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Disconnect the hose from the vacuum (Fig. 2).
3. Remove the vacuum from the wall mount rack.
4. Undo the latches and remove the power head from the collection tank (Fig. 3).
5. Clear all dirt or debris from the collection tank and hose into a proper waste container (Fig. 4).
6. Clean or replace the filters (Fig. 5).
7. Check the hose, attachments, and power cord to verify that they have not been damaged.
8. Place power head back on collection tank and secure latches.
IMPORTANT! Clean or change the cartridge filter regularly for best performance. ALWAYS USE
THE CARTRIDGE FILTER FOR DRY VACUUMING. If the machine is used without the cartridge
filter, the motor will burn out and the warranty will be voided. Always keep spare cartridge filters on
hand.
NOTICE! The filters included are made of high quality materials designed to stop small dust
particles. The cartridge filter should be used for dry pick-up only. A dry cartridge filter is necessary
to pick up dust. If the cartridge filter is wet, it will clog quickly and be difficult to clean. Handle the
filter carefully when removing it for cleaning or replacing. Check the filters for tears or small holes.
A small hole can let dust pass through and out of the filter. Do not use a filter with holes or tears in
it; replace it immediately.
BATTERY INSTRUCTIONS
•
Always purchase the correct size and grade of battery most suitable for the intended use.
•
Always replace the whole set of batteries at one time, taking care not to mix old and new ones,
or batteries of different types.
•
Clean the battery contacts and also those of the device prior to battery installation.
•
Ensure the batteries are installed correctly with regard to polarity (+ and -).
•
Remove batteries from equipment which is not to be used for an extended period of time.
•
Remove used batteries promptly.
Batteries must be disposed of in a specified matter to prevent contamination of the environment.
Before disposing of damaged or worn out batteries, contact your local waste disposal agency, or
the local Environmental Protection Agency for information and specific instructions.
STORAGE
Before storing your vacuum, the collection tank should be emptied and cleaned. The cord should
be wrapped around the cord storage hook located on the side of the vacuum and the hose should
be stored on hose storage rack. Accessories can be stored on accessory storage and wall mount
assembly. The vacuum should be stored indoors when not using.
REPAIRS
Repairs for this wet/dry vacuum should be performed only by qualified service personnel using
only identical replacement parts.
MAINTENANCE
2
ALWAYS DISCONNECT THE PLUG FROM THE POWER OUTLET
3
4
14
5
Advertisement
Table of Contents
