Table of Contents
Advertisement
DRY VACUUM OPERATION
1
6
DRY VACUUMING
WARNING:
ENTITLED "IMPORTANT SAFETY INSTRUCTIONS". DO NOT VACUUM IN AREAS WITH
FLAMMABLE GASES, VAPORS, OR EXPLOSIVE DUSTS IN THE AIR. FLAMMABLE
GASES OR VAPORS INCLUDE BUT ARE NOT LIMITED TO: LIGHTER FLUID, SOLVENT
TYPE CLEANERS, OIL-BASED PAINTS, GASOLINE, ALCOHOL, OR AEROSOL SPRAYS.
EXPLOSIVE DUSTS INCLUDE BUT ARE NOT LIMITED TO: COAL, MAGNESIUM, GRAIN, OR
GUN POWDER. TO REDUCE THE RISK OF HEALTH HAZARDS FROM VAPORS OR DUST,
DO NOT VACUUM TOXIC MATERIALS.
WARNING:
PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
CAUTION:
WITH STANDARD WET/DRY FILTER. THIS IS A VERY FINE DUST WHICH WILL NOT BE
CAPTURED BY THE FILTER AND MAY CAUSE DAMAGE TO MOTOR. WHEN VACUUMING
FINE DUST USE A FINE DUST FILTER (SOLD SEPARATELY).
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. In order to prepare your vacuum for dry vacuuming, verify that the cartridge filter completely
covers the filter cage. Your Wet/Dry Vacuum comes with the cartridge filter pre-installed. For
installation instructions, see page 15 (Fig. 2).
3. Place filter retainer on top of cartridge filter and tighten down by turning the retainer handle
clockwise (Fig. 3).
4. Place the power head back on the collection tank, aligning the top section with the latches, and
lock into place (Fig. 4).
2
3
7
8
BE SURE TO READ, UNDERSTAND, AND APPLY INFORMATION
DO NOT PLUG POWER CORD INTO POWER OUTLET. MAKE SURE
DO NOT VACUUM DRYWALL DUST OR FIREPLACE SOOT OR ASH
4
9
10
5
10
Advertisement
Table of Contents
