Table of Contents
Advertisement
GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screwdriver is required.
WARNING:
PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VAC.
UNPACKING YOUR DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet. (fig.1)
2. Undo the latches. (fig.2)
3. Lift the power head off the collection tank. (fig.3)
4. Remove the contents from inside the collection tank, make sure you have all contents as listed
on page 5. (fig.4)
5. For dry vacuum cleaning, install the supplied reusable cloth filter. (fig. 5) See page 10 for filter
installation.
6. For wet vacuum cleaning, install the supplied foam filter. (fig. 6) See page 10 for filter
installation.
7. Insert the casters into the respective sockets on the bottom of the base. Apply pressure until
castors snap into place. (fig.7)
8. Turn the collection tank upside down and fit the base assembly onto the tank. Secure the base
to the tank with the supplied screws. Verify that the base is assembled correctly. Do not over-
tighten screw. (fig.8)
9. Place the power head back on the collection tank, aligning the top section with the latches, and
snap into place. (fig. 9 & 10)
10. Insert the larger end of the hose into the desired port. (fig. 11)
11. Choose the desired accessories and insert onto the end of the hose. (fig. 12)
For your convenience this vacuum comes with a wall mounting support for storage.
IMPORTANT!
• Do not mount the rack over 5 feet from the floor.
• Do not screw the rack to drywall only. Secure the screws to a stud.
• Do not hang from or sit on the vacuum when on mounting rack.
DO NOT PLUG IN POWER CORD TO POWER OUTLET. MAKE SURE
7
Advertisement
Table of Contents
