Table of Contents
Advertisement
GENERAL ASSEMBLY INSTRUCTIONS
A Philips head screw driver is required.
1
6
11
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE ASSEMBLING THE WET/DRY VACUUM. TO
REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the power head off the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank; make sure you have all contents as listed
on page 6 (Fig. 4).
5. Turn the collection tank upside down and insert the four caster feet into the slots on the
collection tank and tighten with supplied screws. Verify that the casters are mounted correctly.
Do not over-tighten screws (Fig. 5).
6. Insert the handle into the slots located on the top of the power head and secure it with the
screws provided. Do not over-tighten screws (Fig. 6).
7. Your vacuum comes ready for dry vacuum cleaning. If the cartridge filter is not installed, refer
to page 13 for installation instructions (Fig. 7 & 8).
8. For wet vacuum cleaning, remove the cartridge filter, and install the supplied foam wet filter.
See page 14 for the foam wet filter installation instructions (Fig. 9).
9. Place the power head back on the collection tank and secure into place using the latches (Fig.
10).
10. Insert the locking end of the hose into the vacuum port on the collection tank and lock into
place (Fig. 11).
11. Choose the desired attachment and insert onto the end of the hose or extension wand (Fig.
12).
2
1
2
7
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
3
4
8
9
12
7
5
10
Advertisement
Table of Contents
