Table of Contents
Advertisement
1
6
This Wet/Dry Vacuum has blowing capabilities. To use the blower feature follow the instructions
listed.
WARNING:
IN CANADA, CSAZ94.3) BEFORE USING BLOWER.
WARNING:
WARNING:
INHALED.
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Make sure the collection tank is empty before using as a blower. Clear all dirt and debris from
the hose and collection tank.
3. Lift the button on the blower filter door to the unlocked position and flip the blower filter door
open (Fig. 2).
4. Remove the hose from the vacuum port and insert the locking end of the hose into the blower
port on the power head and lock into position (Fig. 3).
5. Fit the desired extension wand and/or nozzle to the free end of the vacuum hose (Fig. 4).
6. Verify that the on/off switch is in the 'O' OFF position before plugging the power cord into the
outlet (Fig. 5 & 6).
7. Before turning ON the vacuum, firmly hold the loose end of the hose. Turn the motor on by
flipping the switch to the 'I' ON position or set the switch to the remote control setting and use
the remote control (Fig. 7).
8. Once you have completed blowing, flip the on/off switch to the 'O' (OFF) position and unplug
the power cord from the outlet (Fig. 8).
BLOWER OPERATION
2
3
7
8
ALWAYS WEAR SAFETY GOGGLES COMPLYING WITH ANSI Z87.1 (OR
KEEP BYSTANDERS CLEAR FROM BLOWING DEBRIS.
WEAR A DUST MASK IF BLOWING CREATES DUST THAT MIGHT BE
4
13
5
Advertisement
Table of Contents
